Applica LitterMaid Elite LME9000 Manuel d'utilisateur télécharger pdf (Page 7)

Tip: To measure litter at the center of the box, insert the

scoop & rake cleaner, scoop down, into the center of the

litter tray. The Fill Line on the scoop is even with the MAX

fill line on the tray (L).

Important: Do not overfill unit or it will not operate

properly.

ATTACHING PAW CLEANING RAMP

1. The paw cleaning ramp has two notches that snap onto the paw cleaning

ramp attachment points on the top housing, directly in front of the waste

receptacle compartment cover.

2. Position the paw cleaning ramp with the carpet side facing up.

3. Place the notches into the paw cleaning ramp

attachment points on either side of the unit (M).

4. Tug slightly on ramp to ensure that it is firmly in place.

INSTALLING RAKE

1. Align tracks on back of rake (each end) and slide into

grooves on motor housing (N).

DAILY USE

1. Remove AC adapter from packaging and plug into the

AC adapter outlet at the back of the top housing (P).

Plug cord into a standard electrical outlet.

2. Turn the ON/OFF switch to ON; the green POWER

indicator light will turn on.

Note: The rake will automatically run through a cleaning

cycle to smooth out litter.

Important: Unit will not start CLEANING cycle while cat is in the box.

3. For daily use, your cat enters the litter box. Once it leaves, the motion

sensors will activate CLEANING cycle. (Sensors must be blocked for at least

10 seconds to activate CLEANING cycle.)

4. The ionizer light will be green, indicating that the ionic air cleaner is

working.

5. After 10 minutes, the automatic rake moves forward and back to scoop

waste clumps into the waste receptacle.

Note: If the cat reenters and leaves the litter box before the initial 10 minutes

have past, the timer will automatically reset and delay the rake action for an

additional 10 minutes.

Note: Rake will stop and reverse direction if the safety bar touches any object

behind the rake as it cycles.

Important: If the rake encounters a blockage, it will attempt to complete its

cleaning cycle 5 times. If unsuccessful, the LED light will blink quickly (see

TROUBLESHOOTING for more details).

6. If small litter particles remain in the litter tray after the rake has completed

a cycle, you can use the scoop & rake cleaner to move these particles to the

waste receptacle.

7. If clumps of litter become stuck to the rake, use the teeth on the scoop &

rake cleaner to clean between the teeth on the rake.

8. The disposable waste receptacle will keep odors and waste trapped until

you are ready to replace the receptacle. Once the receptacle is full, remove

and replace as instructed in REMOVING THE WASTE RECEPTACLE.

SETTING THE CLOCK

Note: The display will blink 12:00 until the clock is set; however, the litter box

can operate normally without the clock being set.

1. Set the clock to the time of day by pressing the HOUR button then minute

(MIN) button.

Note: If setting P.M., be sure light in the upper left corner of the display is lit.

PROGRAMMING THE SLEEP TIMER

Sleep mode deactivates the rake cleaning cycle for 9 hours. During this time,

the ionic air cleaner automatically turns on for 10 minutes every hour to

freshen the air.

After 9 hours, the rake will perform one cleaning cycle and then resume

normal operation. The 9-hour sleep mode and the 15-hour normal operation

repeat at set time every each day.

To Program the Sleep Timer:

1. Set the clock as instructed above.

2. Press the SLEEP SET button on the control panel to begin programming; the

red SLEEP indicator light starts blinking.

3. Press the HOUR and minute (MIN) buttons to set the sleep timer to the time

you want the sleep mode to begin.

Note: If setting P.M., be sure light in the upper left corner of the display is lit.

4. The sleep mode time will be automatically accepted if no buttons are

pressed for 3 seconds or more. The red SLEEP indicator light stops blinking

and turns off.

5. Sleep mode time is now set, but not activated.

To Activate Sleep Timer:

1. Press and hold the SLEEP SET button.

2. Red SLEEP indicator light comes on and stays constant; this indicates the

1 2 3 4 5 6 7 8 9 10 11

Commentaires sur ces manuels

Pas de commentaire

Applica LitterMaid Elite LME9000 Manuel d'utilisateur Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Soins des animaux Applica LitterMaid Elite LME9000